GPIO-based Sysinfo device
This binding describes several GPIOs which specify a board revision. Each GPIO
forms a digit in a ternary revision number. This revision is then mapped to a
name using the revisions and names properties.
Each GPIO may be floating, pulled-up, or pulled-down, mapping to digits 2, 1,
and 0, respectively. The first GPIO forms the least-significant digit of the
revision. For example, consider the property
gpios = <&gpio 0>, <&gpio 1>, <&gpio 2>;
If GPIO 0 is pulled-up, GPIO 1 is pulled-down, and GPIO 2 is floating, then the
revision would be
0t201 = 2*9 + 0*3 + 1*3 = 19
If instead GPIO 0 is floating, GPIO 1 is pulled-up, and GPIO 2 is pulled-down,
then the revision would be
0t012 = 0*9 + 1*3 + 2*1 = 5
Required properties:
- compatible: should be "gpio-sysinfo".
- gpios: should be a list of gpios forming the revision number,
least-significant-digit first
- revisions: a list of known revisions; any revisions not present will have the
name "unknown"
- names: the name of each revision in revisions
Example:
sysinfo {
compatible = "gpio-sysinfo";
gpios = <&gpio_a 15>, <&gpio_a 16>, <&gpio_a 17>;
revisions = <19>, <5>;
names = "rev_a", "foo";
};