.. SPDX-License-Identifier: GPL-2.0+ U-Boot for Apple Silicon Macs ============================= Allows Apple Silicon Macs to boot U-Boot via the m1n1 bootloader developed by the Asahi Linux project. At this point the machines with the following SoCs work: - Apple M1 SoC (t8103) - Apple M1 Pro SoC (t6000) - Apple M1 Max SoC (t6001) - Apple M1 Ultra SoC (t6002) On these SoCs the following hardware is supported: - S5L serial port - SPI keyboard (on laptops) - Framebuffer - NVMe storage - USB 3.1 Type-C ports Device trees are currently provided for the M1 Mac mini (2020, J274), M1 MacBook Pro 13" (2020, J293), M1 MacBook Air (2020, J313) and M1 iMac (2021, J456/J457). Building U-Boot --------------- .. code-block:: bash $ export CROSS_COMPILE=aarch64-none-elf- $ make apple_m1_defconfig $ make This will build ``u-boot-nodtb.bin`` as well as devices trees for some of the supported machines. These device trees can be found in the ``arch/arm/dts`` subdirectory of your build. Image creation -------------- In order to run U-Boot on an Apple Silicon Mac, U-Boot has to be used as a payload for the m1n1 bootloader. Instructions for building m1n1 can be found here: https://github.com/AsahiLinux/docs/wiki/SW%3Am1n1 .. code-block:: bash $ cat m1n1.macho t8103-j274.dtb u-boot-nodtb.bin > u-boot.macho This uses ``u-boot-nodtb.bin`` as the device tree is passed to U-Boot by m1n1 after making some adjustments. Image installation ------------------ Instructions on how to install U-Boot on your Mac can be found at: https://github.com/AsahiLinux/docs/wiki/Developer-Quickstart Just replace ``m1n1.macho`` with ``u-boot.macho`` in the instructions. Debug UART ---------- Since the base address of the UART is SoC-dependent, the debug UART is not enabled by default. To enable the debug UART the base address needs to be adjusted and the CONFIG_DEBUG_UART option needs to be enabled. The table below gives the correct base address for the supported SoCs. .. list-table:: :widths: 32 16 :header-rows: 1 * - SoC - Base Address * - M1 (t8103) - 0x235200000 * - M1 Pro/Max/Ultra (t6000/t6001/t6002) - 0x39b200000