// SPDX-License-Identifier: GPL-2.0 /* * (C) Copyright 2012 Stephen Warren * * See file CREDITS for list of people who contributed to this * project. */ #include #include #include #include #include #include #define RESET_TIMEOUT 10 /* * The Raspberry Pi firmware uses the RSTS register to know which partiton * to boot from. The partiton value is spread into bits 0, 2, 4, 6, 8, 10. * Partiton 63 is a special partition used by the firmware to indicate halt. */ #define BCM2835_WDOG_RSTS_RASPBERRYPI_HALT 0x555 /* max ticks timeout */ #define BCM2835_WDOG_MAX_TIMEOUT 0x000fffff void hw_watchdog_disable(void) {} __efi_runtime_data struct bcm2835_wdog_regs *wdog_regs; static void __efi_runtime __reset_cpu(struct bcm2835_wdog_regs *wdog_regs, ulong ticks) { uint32_t rstc, timeout; if (ticks == 0) { hw_watchdog_disable(); timeout = RESET_TIMEOUT; } else timeout = ticks & BCM2835_WDOG_MAX_TIMEOUT; rstc = readl(&wdog_regs->rstc); rstc &= ~BCM2835_WDOG_RSTC_WRCFG_MASK; rstc |= BCM2835_WDOG_RSTC_WRCFG_FULL_RESET; writel(BCM2835_WDOG_PASSWORD | timeout, &wdog_regs->wdog); writel(BCM2835_WDOG_PASSWORD | rstc, &wdog_regs->rstc); } void reset_cpu(void) { struct bcm2835_wdog_regs *regs = (struct bcm2835_wdog_regs *)BCM2835_WDOG_PHYSADDR; __reset_cpu(regs, 0); } #ifdef CONFIG_EFI_LOADER void __efi_runtime EFIAPI efi_reset_system( enum efi_reset_type reset_type, efi_status_t reset_status, unsigned long data_size, void *reset_data) { u32 val; if (reset_type == EFI_RESET_COLD || reset_type == EFI_RESET_WARM || reset_type == EFI_RESET_PLATFORM_SPECIFIC) { __reset_cpu(wdog_regs, 0); } else if (reset_type == EFI_RESET_SHUTDOWN) { /* * We set the watchdog hard reset bit here to distinguish this reset * from the normal (full) reset. bootcode.bin will not reboot after a * hard reset. */ val = readl(&wdog_regs->rsts); val |= BCM2835_WDOG_PASSWORD; val |= BCM2835_WDOG_RSTS_RASPBERRYPI_HALT; writel(val, &wdog_regs->rsts); __reset_cpu(wdog_regs, 0); } while (1) { } } efi_status_t efi_reset_system_init(void) { wdog_regs = (struct bcm2835_wdog_regs *)BCM2835_WDOG_PHYSADDR; return efi_add_runtime_mmio(&wdog_regs, sizeof(*wdog_regs)); } #endif